DBT - Embossing stops working after home router changed

DBT - Embossing stops working after home router changed

Problem

An Index user encounters a problem  whem embossing from DBT software where embossing no longer appears to work after changing their home router. 

Applies to

  1. DBT and Index embosser

Resolution

If the embosser does not respond to print jobs from DBT this may be the result of the IP address of the embossser being changed and needs tobe updated on the printer driver settings.  

Check new IP address

If you are able to contact the embosser using the browser you can use the IP address that reaches the web interface successfully.  You can also verify within the web interface using these steps:

If you wish to double check you can open command prompt then enter this command:

ping <embosser IP>

You should then see replies indicating that the embosser is responding confirm It is active on the network.

Configure new IP address

  1. Open Settings → Bluetooth & devices → Printers & scanners.
  2. Select the Index embosser printer.
  3. Click Printer properties.
  4. Go to the Ports tab.
  5. Look for a port such as:
  6. Standard TCP/IP Port
  7. Or a port showing the old IP address.
  8. Click Configure Port...
  9. Change the Printer Name or IP Address field to the new IP address.
  10. Click OK and Apply.

Greyed out  Configure Port?

If when attempting to  assign a new port you are unable to configure a new port becuase the button is greyed out proceed using the steps below:

  1. In Printer Properties → Ports tab.
  2. Click Add Port...
  3. Select Standard TCP/IP Port.
  4. Click New Port...
  5. Enter the embosser's new IP address.
  6. Finish the wizard.
  7. Tick the newly created port and click Apply.