Embossing Index test pages (V2. V3. V4)

Embossing Index test pages (V2. V3. V4)

Problem

You wish to emboss a test page to check if the embosser is working correctly.

Resolution

Use the solution that matches the version of your embosser below.

v2

Hammer test - Hold the Online button as powering it on and wait for the beep.

v3

Hammer test - Press Help then Online.
Embosser information in Braille - Help then Normal.
Embosser information in text - Help then Help.

v4

  1. Press Menu
  2. Arrow down to Option, press OK
  3. Arrow down to Emboss Without Computer, press OK.
  4. There are a few options here including:
  • Braille manual - emboss the entire Index manual in Braille. Useful to test embossing a long document & regular braille.
  • Hammer test - will test all solenoids so you can tell if one is faulty.
  • Embosser information - shows information including serial & firmware version. (You can alternatively hear this information by just pressing Help instead)

    • Related Articles

    • Index - embosser test pages

      Information Below are front panel combinations to have the embosser produce test pages. Affected products Index embossers V2/V3/V4 Application Test page sequences may be used for fault finding for embosser independent of computer/drivers/Braille ...

    • Mountbatten – Emboss a test page to check embossing quality

      Problem There are problems Mountbatten embossed output and one needs to check using a standard test print. Resolution Use the steps below to make a test print with the Mountbatten to check the embossing head is working correctly. If commands are not ...

    • Duxbury setup with Index embossers

      Information Documentation provided by Will on setting up Duxbury DBT and Index embossers. Index embosser setup outline Install/activate Duxbury. Install the Index drivers. Set the paper size on the embosser. Set up the embosser in Duxbury: Select the ...

    • Index V4 embosser service commands

      Information Below service commands are availalable for V4 embossers running firmware version 1.5.2 or above. (Not to be confused with the boot-time service mode or service cable.) Entering service mode manually To enter service mode manually press ...

    • Duxbury error 213 posted when embossing to Index embosser

      Problem When sending an embossing job to an Index V4 embosser Dubxury Braille Translator software posts error 213. Resolution Make sure the Index printer driver and IbPrint version 6.3.7 or later are installed on your PC. These files are available ...