Index embosser settings reset
Problem
You wish to reset all paper sizes on the Index embosser.
Resolution
Please use the steps apropriate to the version of your Index embosser below.
This will reset all the paper size settings etc on the embosser itself.
v2
Hold Group whilst powering on and wait for the beep.
v3
Press Setup then Normal
v4
Hold pinhole reset button on back of unit for 3 seconds, with a small screwdriver or pin.
Related Articles
Index v3 reset
Problem You identify a problem with Index V3 embosser and determine a reset may resolve the issue. Resolution The following will reset the firmware on the Index v3 embossers back to default. It is more in-depth than the standard setting reset. It may ...Index V4 embosser service commands
Information Below service commands are availalable for V4 embossers running firmware version 1.5.2 or above. (Not to be confused with the boot-time service mode or service cable.) Entering service mode manually To enter service mode manually press ...Index - embosser test pages
Information Below are front panel combinations to have the embosser produce test pages. Affected products Index embossers V2/V3/V4 Application Test page sequences may be used for fault finding for embosser independent of computer/drivers/Braille ...Index - Embosser version identification
About The Index embosser family have developed over a number of generations with introduction of new features and capabilities and interface standards. This document provides information to facilitate identification of the generation of embosser ...IDB - Using Index Direct Braille
Problem A customer with an Index V5 embosser wishes to use Index Direct Braille translation software. Detail Index-direct-Braille is a tool to quickly emboss Braille from simple PDF and Word documents if no other Braille translation software is ...