Below listed are known error codes for V4 embossers running firmware version 1.4.1 or later.
100: communication not configure
101: communication timeout
102: restart communication
103: reset printing queue
120: Out of paper
121: Paper jam
122: Paper length fail
123: Paper tray empty
130: Service door open
131: Paper tray open
132: Braille tray open
133: No tray signal open
134: Braille tray full
135: Paper jam - release
150: No dynamic ip address
200: document receiving error
201: document file empty
202: document unknown esc sequence
203: document winBraille file
204: document xml format
205: document html format
206: document post script file
210: document v3 format
211: document v2 format
212: document min value
213: document max value
214: document max char per line
215: document max lines per page
216: document to many transparent characters
220: document unknown parameter
221: document missing parameter
299: document formatting error
300: upgrade file checksum error
301: upgrade file has not a valid magic number
302: upgrade fil has not a valid header
400: undefined hardware setup
401: alignment board not working
500: undefined software setting
501: allocate memory error
502: free memory error
503: large document error
800: no sd card available
801: sd card is read only
802: no factory settings
810: configuration file is corrupt
811: parameter file is corrupt
812: layout file is corrupt
813: embosser header file is corrupt
814: network file is corrupt
999: restart embosser
700: Ink timeout
701: Ink startup
702: Ink power up
703: Ink Power down
704: Ink postservice
900: test missing layout file
1000: information message
1001: save test document
1002: format document test failed
2000: warning message