Mountbatten - Advanced commands not working

Mountbatten - Advanced commands not working

Problem

When using Mountbatten advanced commands do not appear to be working. 


Resolution

By default, the Mountbatten ships in Learn mode, whilst so set many features are disabled. If you wish to unlock Advanced Mode use the steps below to enable it. 

  1. Press LF (backtab), RF (tab), New Line, and Space together as a chord. This shortcut acts as a toggle to turn on commands, when enabled will speak "Commands on".
  2. Then press the Command button followed by the letter "adv" (dot 1, dots 1-4-5, dots 1-2-3-6).
  3. Press Enter.  Advanced mode is then enabled.

Step 1 diagram (press keys in black together):


    • Related Articles

    • Mountbatten – Activate command mode

      Problem You wish to enable command mode for more advanced functionality of the Mountbatten Brailler. Applies to: Mountbatten Mountbatten Whisperer Resolution The Mountbatten has two main modes of operation Learn mode and Advanced mode. In Learn mode ...

    • Harpo - Mountbatten Brailler product information (Internal)

      About The Mountbatten range are a family of electronic Braille writing machines enhanced with software for Braille and Braille music education. At its most basic level it can be used as an electronic Perkins mechanical Brailler but without the strain ...

    • Mountbatten - Reset procedure

      Problem A Mountbatten Tutor (MBT) is not working as expected, a reset may fix the problem. Applies to Mountbatten Mountbatten Whisperer Resolution Use the methods below to carry out Mountbatten resets. Warning! This procedure only for the older ...

    • Mountbatten - Replacement Mountbatten charger

      Problem A Mountbatten customer needs to source a suitable replacement charger for their Mountbatten. Applies to Mountbatten Brailler Mountbatten Whisperer Resolution Where possible customers are encouraged to purchase the following item from Sight & ...

    • Mountbatten - Responds by speaking "error" when changing dot impact level

      Problem When using the hotkey combinations command + backtab (increase impact level) or command + tab (decrease impact level) to change the dot impact, the speech "error" is heard. Applies to Mounbatten Resolution The dot impact commands are only ...