Mountbatten – Emboss a test page to check embossing quality
Problem
There are problems Mountbatten embossed output and one needs to check using a standard test print.
Resolution
Use the steps below to make a test print with the Mountbatten to check the embossing head is working correctly.
- If commands are not enabled, press LF (backtab), RF (tab), New Line, and Space together. After pressing this key chord the Mountbatten should say "Commands on".
- Press Command followed by dots 2-5, then Enter.
Related Articles
Embossing Index test pages (V2. V3. V4)
Problem You wish to emboss a test page to check if the embosser is working correctly. Resolution Use the solution that matches the version of your embosser below. v2 Hammer test - Hold the Online button as powering it on and wait for the beep. v3 ...
Index - embosser test pages
Information Below are front panel combinations to have the embosser produce test pages. Affected products Index embossers V2/V3/V4 Application Test page sequences may be used for fault finding for embosser independent of computer/drivers/Braille ...
Mountbatten - Check battery status/charge level
Problem You wish to check the battery status/charge level to ensure the battery doesn't become too low. Resolution Use the key chord Space + Newline + B (dots 12) The Mountbatten unit will then speak the batterry status. If it is very low it is ...
HP - Deskjet 2710/2710e - Print output blank, incomplete or poor quality (Head clean solution)
Problem When you ask the HP 2710 to print it produces incomplete or blank pages. Applies to HP Deskjet 2710 and 2710e Resolution Things to consider: Check that ink levels are good on the printer and replace emtpy ink. If the printer has been idle for ...
Focus - Enter test/clean mode
Problem You wish to run the Focus test/clean mode in order to test/clean Braille line or test buttons. Applies to Focus Braille displays Resolution Application This may be useful in the following circumstances: Braille pins that are stuck down or up ...