Pairing Aftershokz Bluez 2 headset
Problem:
You wish to pair the Aftershokz Bluez 2 headset with a phone or other playback device.
Resolution:
- If the headset is powered on press and hold the power button until the headset powers off.
- Press and hold the hold down the power button for greater than 5 seconds so you hear both the power on beep and then the word "pairing" spoken in the earpiece.
- If you do not hear “pairing” spoken power off the unit, then repeat the process holding the power button for longer so that the headset not only powers on but also goes into Bluetooth pairing mode.
Notes:
For connection to a specific device please consult the manufacturer’s documentation.
Related Articles
Pairing tips
Information Below are helpful tips for pairing the Sunuband with the smartphone app. Verify that Bluetooth is activated, and the Sunu App has access to Bluetooth permissions. (You may verify this on Settings of the phone itself.) If everything seems ...
Focus Bluetooth pairing problems and solutions
Problem When attempting to pair the Focus using the VoiceOver Braille display options you receive a message stating “pairing unsuccessful” and pairing fails. General guidelines • Make sure the IOS device is as up to date as possible by going into ...
ANR-1000 - Using headset microphone with wired connection
Problem/Question This document clarifies ambiguous documentation regarding use of headset micrphone in wired connection scenario. Detail The headset is supplied with a 3 conductor aux cable but the manual does not make if clear if the microphone will ...
Connecting a bluetooth headset to the SmartVision2
To do this, you must activate the Bluetooth connection: in Settings, activate Bluetooth and open Bluetooth to detect all devices in the vicinity. Select the model of the headset you want to connect and press "OK" to pair and then enter the pin code ...
Smart Beetle Bluetooth pairing with iOS mobile devices
Information Please use the steps below to pair Smart Beetle with your IOS device and VoiceOver: Turn on your Smart Beetle and make sure it is in "Pairing BRL" Mode. On your iPhone, navigate to Settings/General/Accessibility/VoiceOver/Braille. If ...