A ZoomText customer wishes to use know if ZoomText support a touch screen.
Two touch modes exist for carrying out different kinds of commands:
This mode passes all gestures to the Windows system and underlying applications. Whilst in this mode you cannot activate ZoomText specific gestures.
The icon below denotes that ZoomText is in Windows Touch mode
This mode allows access to various ZoomText specific
features.
In this section you will learn how to use the ZoomText Touch Icon and gestures to access and operate key ZoomText features.
Remember that the Touch Icon must be in ZoomText Touch Mode when performing these gestures.
To display the ZoomText user interface
Double-tap with four fingers.
To adjust the magnification level (zoom in and out)
Double-tap and hold three fingers, then drag up to zoom in and
drag down to zoom out.
To pan the magnified view
Drag three fingers to move around the screen.
To adjust the size and location of a zoom window
1. On the Magnifier toolbar tab, choose Window > Zoom
Windows Adjust Tool.
The Adjust tool becomes active and sizing handles appear on the
zoom window frame.
2. To resize the window, hold one finger on a sizing handle and
drag it until it’s the size you prefer.
3. To move the window, hold one finger inside the zoom window
and drag it around.
4. To exit the Adjust tool, double-tap with three fingers.
To use View Mode
1. Double-tap with three fingers.
Magnification is temporarily turned off and the view locator
appears.
58
2. To move the view port, hold one finger inside the view port and
drag it to the desired location.
3. To exit View Mode and be moved to the new viewport location,
double-tap with one finger.
4. To exit View Mode and move to the previous viewport location,
double-tap with three fingers.
To use the SpeakIt Tool
1. On the Reader toolbar tab, choose SpeakIt.
The SpeakIt tool becomes active and sizing handles appear on the
zoom window frame.
2. To speak a single word, tap on the word.
3. To speak a block of words, drag diagonally with one finger to
highlight the words you want to have spoken. When you
complete the drag, all highlighted text will be spoken.
4. To exit the SpeakIt tool, double-tap with three fingers.
To use AppReader
1. Open the document, web page or email that you wish to read.
2. Start AppReader using one of the following two methods:
To start reading at any word: Double-tap with one finger
on the word where you want to start reading.
To start reading from the location of the text cursor,
double-tap with two fingers.
AppReader begins reading.
3. To start and stop reading or navigate/read by word, line,
sentence and paragraph, use the AppReader Reading Gestures
listed in the table below.
4. To speak a block of words, drag diagonally with one finger to
highlight the words you want to have spoken.
When you complete the drag, all highlighted text will be spoken
Chapter 4—The ZoomText User Interface 59
5. To exit AppReader, double-tap with three fingers.
When AppReader exits, the cursor is automatically positioned at
the last word that was highlighted in AppReader (if a cursor exists
in the application).
AppReader Reading Gestures
Command Gesture
Toggle Reading
(Play/Pause)
2-finger single-tap
Read from new location 1-finger single-tap.
Say Next Word 1-finger swipe right
Say Previous Word 1-finger swipe left
Say Current Word 1-finger double-tap
Note: Repeating this gesture on the same word
within two seconds or less will cycle through
the following options: say/spell/military spell.
Resets after a lapse of more than two seconds.
Say Word Below 1-finger swipe down
Say Word Above 1-finger swipe up
Say Next Sentence 2-finger swipe right
Say Previous Sentence 2-finger swipe left
Say Next Paragraph 2-finger swipe down
Say Previous Paragraph 2-finger swipe up
End of Document 4-finger swipe down
Beginning of Document 4-finger swipe up