Viewplus Rogue embosser driver setup (standalone and network)

Viewplus Rogue embosser driver setup (standalone and network)

Information

This document describes the basic steps of driver installation for Viewplus Rogue Braille embosser.

Steps

Important!
  • Do not connect the embosser to a computer before running the driver installation.
  • Administrator credentials will be required to install the embosser driver successfully.

Standalone installation

  1. Run the VP Rogue driver installation software, accept the license agreement and responding to the other prompts to complete installation.
  2. Then click Finish on the installation wizard.
  3. After installation connect the embosser using USB to have the embosser detected by the operating system.

Network installation

  1. Run the VP Rogue driver installation software, accept the license agreement and responding to the other prompts.
  2. When you get to the screen showing the finish button do not click finish yet, instead connect the embosser initially with USB to have it detected by Windows. If at first it is not detected unplug the USB and then plug USB back in to have Windows detect the embosser.
  3. After the printer has been detected locally hook up a LAN cable to the ethernet port and then click the checkbox for “Run network printer installation utility”. This will call the network installation utility to start.
  4. Then click Finish button for driver installation.
Tip

The utility can also be accessed via the Viewplus group in the start menu.

Once all the above are complete TSS software can be installed, this allows activation on one computer.

    • Related Articles

    • Viewplus – Rogue embosser halts for no reason during a job

      Problem Whilst embossing a job the Viewplus Rogue halts embossing, if you attempt to print again the job is embossed from the beginning again. Resolution A problem has been discovered that is fixed in a firmware update below for the Viewplus Rogue. ...

    • Viewplus – Diagnosing SpotDot embosser problems using driver diagnostic information

      Problem A customer using a Viewplus SpotDot has a front panel error from the embosser and needs further information regarding the error condition. Applies to Emprint SpotDot Resolution use either set of instructions to view any possible error codes ...

    • Viewplus - Embosser firmware update (All models)

      Problem A customer wishes to update the firmware on their Viewplus Braille embosser. Applies to Elite & Premier Embosser Max & Cub (Desktop) Embosser EmBraille Embosser Columbia & Delta Embosser Rogue Embosser EmFuse Color Braille Station SpotDot ...

    • DBT setup for Viewplus embossers

      Problem: You have duxbury and need to set it up to work with a Viewplus embosser. Resolution: Open Duxbury then choose Global > Embosser Setup. Click "New" button and then select Viewplus embosser. Add a setup name. Select "Send to printer" radio ...

    • Index V5 - Wireless setup

      Information: Please use the directions below to get an Index V5 embosser onto the network. Applies to Index V5 series embossers Setup communication with WPS (push button) Most modern routers have support for WPS (Wireless Protected Setup), for more ...